Power Module V1.0 / T- Plug for APM2.8 APM2.6 APM Pixhawk Flight Controller
The APM Power Module is a simple way to provide your APM FC with clean power from a LiPo battery, as well as current draw and battery voltage measurements, all via a 6-pos cable. The onboard switching regulator outputs 5.3V and a maximum of 2.25A from up to a 4S LiPo battery. The Power Module comes fully assembled with Deans connectors, and shrink-wrapped for protection.
Used to detect battery voltage and battery current, flight control board receives two signals, calculate remaining battery power, estimate remaining flight time. In addition, the module also comes with BEC function, it can output 5.3 DC, 3A maximum continuous current for the flight control board to provide stable power supply. Other signal cable connectors are used in Japan original fittings, non-domestic board, so the APM flight control board and power supply module reliable connection between.
Max input voltage: 30V
Max sensing current: 90A
Net weight: 25g
Voltage and current measurement configured for 5V ADC
Switching regulator outputs 5.3V and 3A max
6-pos DF13 cable connects directly to APM 2.5’s ‘PM’ connector
Note: The power module is only designed to power APM, an RC receiver and APM accessories (GPS, 3DR radio). It isnotdesigned to power servos. Using your own aircraft ESC/BEC for that.
The control panel input maximum voltage 20V, maximum measurable current 90A, to achieve power and battery voltage control. The design of voltage and current detector parameters of the design consistent with official 3DR Ground Station (planer mission) settings can be adjusted directly refer to the official wiki.
1 x Power Module for APM V1.0